METAL LATHE QUICK CHANGE TOOL POST TURRET Marked 250 - 100. Please use pictures as part of the description. The pictures show all that is included, and the condition so please look closely. Feel free to ask any questions. We take great pride in our customer service! We will do the same!   

Nice Dorian DSIT-60 4 Way Position Indexing Turret Tool Post Large Lathe. This tool post is in excellent condition. Top quality, Made in USA. Been sitting around the shop for maybe 10 years. This is a big turret. It was slated to go on a 25 lathe. I believe the 60 series were suggested for 25-32 machines. CCan accept up to 1 1/2 tool holders. No handle, you'll need to spin one up on the lathe. The knobs are available at McMaster-Carr.   

This is a 4-Position Square Index Turret Tool Post. Can be used with Dorian DQCB-35 Quick Change Base to accommodate for D35CXA Tool Holders. Overall Dimensions: 4-1/2" x 4-1/2" x 8-1/2 high. Comes exactly as shown in pictures.   

Southbend Turret tool post with lever mechanism, i think this is for use with the double tool cross slides but i do not have one to see if it mounts to one or not. Be sure to view our other items for more great tooling finds.   

4-Way Quick Change Tool Post Holder 3" x 3" - Was Used On Hardinge Turret Lathe.   

THE BLOCK TURNS AND LOCKS DOWN LIKE IT SHOULD. THE MOUNT HOLES ON THE BOTTOM ARE 3 1/8 APART O. THE CENTER STUD IS 1 5/8 X 1/8H APPROX. THE DISTANCE FROM THE BOTTOM OF THE BASE PLATE TO THE CENTER OF THE SLOT FOR THE TOOL HOLDER IS 2 3/4 APPROX. THE SLOT FOR THE TOOL IS 11/16 APPROX. THERE ARE A COUPLE RUSTY SPOTS ON IT THE ASSEMBLY. ONE SET SCREWS IS MISSING ON THE BLOCK. THERE ARE MEASUREMENTS IN THE PICTURES. CHECK OUT MY OTHER LISTINGS. NO WARRANTIES GIVEN OR IMPLIED. International Buyers - Please Note. I do not mark merchandise values below value or mark items as "gifts" - US and ...

Nice 4 position lathe tool post made by Dicksons. Looks to be new old stock- no signs of use. Just a bit of surface rust.   

Prefer to pick it up yourself?   

THE BLOCK TURNS AND LOCKS DOWN LIKE IT SHOULD. THE MOUNT HOLES ON THE BOTTOM ARE 3 1/8 APART O. THE CENTER STUD IS 1 5/8 X 1/8H APPROX. THE DISTANCE FROM THE BOTTOM OF THE BASE PLATE TO THE CENTER OF THE SLOT FOR THE TOOL HOLDER IS 2 3/4 APPROX.   

THE BLOCK TURNS AND LOCKS DOWN LIKE IT SHOULD. THE MOUNT HOLES ON THE BOTTOM ARE 3 1/8 APART O. THE CENTER STUD IS 1 5/8 X 1/8H APPROX. THE DISTANCE FROM THE BOTTOM OF THE BASE PLATE TO THE CENTER OF THE SLOT FOR THE TOOL HOLDER IS 2 3/4 APPROX.